johnam71

Hi all Is it possible to wire a basic wah (crybaby) so the toe switch when turned off feeds an added expression out? ie. toe switch on, runs as the std wah and when clicked off feeds the exp out and runs as an exp pedal

This is my setup which sounds amazing Setup is in 2 paths coming out of 1/4 outs L & R and through 2 x EHX 44 Magnum power amps and and 2 celestion loaded cabs The setup I have maximises the DSP IMO Path 1A Feeding both amps: Compressor-Noisegate- wah- Vibe- OCD-Klon-TS808 - splits here 1B : trem and chorus into a VOX AC30 - IR then to path 2B: EP Booster (for solos) then either a D8/or 1/4 Delay - Delay 2 for ping pong - Octoverb - Plate verb Path 2A: trem and chorus into a Fender US Deluxe then to EP Booster (for solos) then either a D8/or 1/4 Delay - Delay 2 for ping pong - POG - Plate verb The second delay on each path is setup manually to give a stereo Pin pong effect The Octo and POG are used for swells and come on together in a Snapshot Path 1 is panned 100%R and path 2 100% L Both cabs are mic'd in a live setup back stage in ISO cabs and fed to mixer which pans L/R in FOH Really sounds incredible. I run the master volume of Helix at 12 o'clock The 44 magnums at around 10 o'clock. The amp models I use are the VOX AC30 "Amp" and Deluxe "preamp" The VOX "preamp" model is very weak. The Deluxe preamp is fine Experiment with other amp models. The Marshall, Mesa, Trainwreck, Orange preamps all work well. The Matchless needs to be set as "AMP"?? Don't know why some pre-amps are so weak compared to others. The problem in going to AMP models is lack of DSP with this setup as it pretty much uses it all Anyway, this is what I have come up with after much experimenting and it sounds the best by far. I have tried Mono, XLR direct, lots of IRs etc, but this set up sounds great. The added benefit is both power amps fit in your gig bag and you just need 2 1x12 cabs!!

Digital Igloo I have setup the attached stereo setup, however I cannot seem to be able to use the 1/4 L and R outputs and assign each of these separate paths to pan R and L. I am in essence trying to maximise the DSP and run 2 modelled amps out into 2 power amps and then ISO cabs. The ISO cabs are then mic'd to the PA and panned L/R for a stereo setup The chain is setup to have drives feed into both amps and then delays post amps going separate outputs Is there a way to do this using the L/R 1/4 inch outs? It works as I have setup, however the master volume only affects the 1/4 out (Left signal) and not the Send/Ret out (Right signal)