Search the Community
Showing results for tags 'output mix'.
Found 2 results
-
Hello, I just got my Helix floor, and try to figure out the following setup: I want to use it live for my guitar *and* vocals and have the signals independent. So the Upper Chain should be: Git In => XLR Left and the lower chain MIC In => XLR Right. As I can only assign XLR out (and not XLR Left / Right) I was assuming panning the XLR out of the upper chain all the way LEFT would cause the signal to go to the XLR Left out only. And if I'd pan it all the way Right, there should be no signal through XLR Left at all (because all goes to right). But panning to left or right just lowers the volume of the signal and there is no difference between panning it to the left or panning it to the right. So it seems to me, that there is some "Stereo to Mono Summation" or something like this happening. I was looking for a "set XLR to Mono" Switch but found nothing. I have not changed the setting of the Helix, just updated the firmware to 03.11. My test setup is just the guitar in and XLR out LEFT => Audiointerface. The upper chain has Guitar In Input and XLR output, the lower chain has MIC In and XLR out (though I did not connected any cables to MIC IN and XLR Right yet). Any idea, how I can fix this? Thanks in advance, Frank
-
Hi there! Here's what I'm trying to do: 1) Create a clean signal that will play straight through, center pan. Easy. 2) Take the same signal and run it panned hard left through a delay and pitch transposer where the wet only signal plays 260ms AFTER the original signal, dropped -7th via pitch but no original note, only the -7th, panned hard left. 3) Using the same original signal, run it panned hard right through a delay and pitch transposer where the wet only signal plays 520ms AFTER the original signal, raised +5th via pitch but neither the original signal nor the left dropped 7th coming through. Center, then hard left dropped a 7th, then hard right raised a 5th. Three notes, not overlapped. Center, left, right. This is day one with my new POD HD PRO X. Thank you!
