seancsmith89 Posted June 19, 2015 Share Posted June 19, 2015 HI all, Currently looking i investing in the Rackmounted Line 6 POD HD but there is an issue I would like to clear up before I purchase. I am currently using an old Boss GT-8 which is absolutely diabolical in terms of sounds. I set up in the 4cm so that I can place certain effects before and after the preamp (Marshall JCM 2000 DSL). When I set up the signal chain, I can place the pedals external effects loop into the chain as an active component. IE: WAH>>VOLUME PEDAL>>OVD>>(Unused inbuilt preamp simulators)>>EQ>>EXTERNAL EFFECTS LOOP>>CHORUS>>DELAY>>REVERB All of the above are interchangeable so I can have any signal chain I wish. My worry is, that, from the online videos I have looked at, and a quick glance of the manual, I cannot figure out where the external effects loop in in the POD's signal chain. Am I missing something here? Quote Link to comment Share on other sites More sharing options...
rd2rk Posted June 19, 2015 Share Posted June 19, 2015 Like any other effect, you put it anywhere you want. Quote Link to comment Share on other sites More sharing options...
CipherHost Posted June 20, 2015 Share Posted June 20, 2015 My worry is, that, from the online videos I have looked at, and a quick glance of the manual, I cannot figure out where the external effects loop in in the POD's signal chain. It is not a default block like the amp / pre amp block is. You have to add it to your signal chain like other effects. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.