chessum Posted October 17, 2015 Share Posted October 17, 2015 Set up 2 signal paths using same source (variax jtv69), work fine, but i cant figure out how you turn them (signal paths) on and off independently (other than using volume blocks), I can see the odd preset that has a switch assigned to do this but cant figure how to add and assign. Any one out there cracked this? Cheers Quote Link to comment Share on other sites More sharing options...
Digital_Igloo Posted October 19, 2015 Share Posted October 19, 2015 Footswitches can be assigned to blocks, parameters, and Command Center messages. If your tone doesn't have a Split block (which can be set to A/B, which can be assigned to a footswitch), volume blocks are the key. There are two template presets already set up for this: 8 TEMPLATES > 02C TwoTones A-B and 02D TwoTones Blend. 1 Quote Link to comment Share on other sites More sharing options...
jaminjimlp Posted October 19, 2015 Share Posted October 19, 2015 I made a preset like this last night I made it acoustic sound and since my volume pedal works backwards I only changed one of the paths to wear it works correctly the second path is a nice distortion sound so when I move expression pedal (I have a one mission engineering one) if I push it toe down I have one path but when I put it heel down I have the other path or I can stop in the middle and mix them. I had to put the volume pedal at the beginning of each path and assign them both to expression pedal two and then change the max 0 and the minimum to 100 on one of them Quote Link to comment Share on other sites More sharing options...
chessum Posted October 20, 2015 Author Share Posted October 20, 2015 Thanks for the feed back. WIll have a go. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.