MrMike Posted August 1, 2022 Share Posted August 1, 2022 Snapshot 1 has a distortion block (screamer) with gain set at say 4 and level at 7. I want Snapshot 2 to be identical in every way as Snapshot 1 except that I want the gain on the screamer to push up to 7 and the level to 9. I want to save the preset as described. Can this be done and how do I do it? The obvious reason is that I just want more punch out of the screamer when moving from Snapshot 1 to Snapshot 2 thanks and I hope this makes sense Quote Link to comment Share on other sites More sharing options...
silverhead Posted August 1, 2022 Share Posted August 1, 2022 You need to assign both parameters to the Snapshot controller. Set the levels you want for Snapshot 1 and Save the preset. Set the levels you want for Snapshot 2 and Save the preset again. Details are in the Snapshots section of the manual. 2 Quote Link to comment Share on other sites More sharing options...
rd2rk Posted August 1, 2022 Share Posted August 1, 2022 Assign both parameters to SNAPSHOTS (RTM). Save each SNAPSHOT (by saving the Preset) with those parameters set as desired. When the SNAPSHOTS behave the way you want, SAVE the Preset with whichever SNAPSHOT you want to be the default that loads with the Preset. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.