Mierswa Posted July 10, 2023 Share Posted July 10, 2023 I have recently made my FW upgrade to 3.60 and realized that in Helix Control, the two rows for patches are in wrong sequence. Wrong means, before the upgrade the 001 Patch was in the upper left position. Now it is in down left. Any idea, how I can change this back? Thanks Sebastian Quote Link to comment Share on other sites More sharing options...
silverhead Posted July 10, 2023 Share Posted July 10, 2023 The firmware update resets the device’s Global Settings to factory defaults. You can restore them to the previous settings by restoring the backup file that your created during the update procedures. Quote Link to comment Share on other sites More sharing options...
PierM Posted July 10, 2023 Share Posted July 10, 2023 Global Settings--->Footswitches--->Swap UP/Down Quote Link to comment Share on other sites More sharing options...
Mierswa Posted July 20, 2023 Author Share Posted July 20, 2023 Thanks a lot, that helped! Sometimes it is even good to read the manual. 1 Quote Link to comment Share on other sites More sharing options...
silverhead Posted July 20, 2023 Share Posted July 20, 2023 On 7/20/2023 at 1:52 AM, Mierswa said: …! Sometimes it is even good to read the manual. Horrors!! I was under the impression that reading a manual left one in the same condition as George in that Seinfeld episode…. “It’s shrinkage!!” Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.