marcio58 Posted August 5, 2023 Share Posted August 5, 2023 Hi, guys. I got an HX Stomp (love it). I use footswitch mode and snapshots together (I keep it basically in footswitch mode and use an external footswitch to change snapshots sequentially). For example, in Snapshot 1 I have a clean amp, in Snapshot 2 I have an edge of breakup drive, and so on. For the Snapshot 1, I use a more pronounced reverb, and I use Footswich 1 to make the mix go, for example, from 20 to 40. But, for Snapshot 2, this values would be too high. Is there a way to make one parameter to vary in a certain range when pressing a footswitch (in footswitch mode) while in Snapshot 1, but to vary in a different range in Snapshots 2 and 3, when pressing the same footswitch? For example, to use Footswitch 1 to make the reverb mix go from 20 to 40 (for example) in Snapshot 1 (and then return to 20 when I press it again), but go from 15 to 30 in Snapshot 2? I tried the Command Center, but could not figure it out. Excuse me for my poor english, and thank you in advance. Quote Link to comment Share on other sites More sharing options...
Schmalle Posted August 5, 2023 Share Posted August 5, 2023 On 8/5/2023 at 4:20 PM, marcio58 said: [...]Is there a way to make one parameter to vary in a certain range when pressing a footswitch (in footswitch mode) while in Snapshot 1, but to vary in a different range in Snapshots 2 and 3, when pressing the same footswitch? [...] AFAIK no. But you could try this workaround: Put the reverb on Path B and set it's Mix to 100%. Path A now has the dry signal, Path B the wet signal. The mix is now controlled by the level of the reverb and there are two parameters that do that: the reverb's Level and the mixer block's B Level. Control the reverb's Level with Footswitch 1 to toggle between two values (i.e. -6dB and 0dB). Control the Mixer Block's B Level with Snapshots. 1 Quote Link to comment Share on other sites More sharing options...
marcio58 Posted August 6, 2023 Author Share Posted August 6, 2023 Thank you, Schmalle. Gonna try it. Quote Link to comment Share on other sites More sharing options...
datacommando Posted August 7, 2023 Share Posted August 7, 2023 On 8/5/2023 at 3:20 PM, marcio58 said: I tried the Command Center, but could not figure it out. Hi, Have you tried using stackable snapshots? Hope this helps/makes sense. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.