Pod go as full board to mixing board and PA

[efwfew]

Hey everyone! I’m using the Pod Go as my full live board going direct into a mixing board/PA. My technical knowledge of this stuff is basically -1 so id appreciate any help, especially if i need to buy something as i have a gig next week

I’ve used the Pod Go live 3 times so far.

Currently I plug a standard instrument cable out of the left/mono output on the pod go and straight into the mixing board. I also plug a cheap in ear system out of the phone out output

 

I usually set the main volume knob on the pod go close to max.

I also have a 1/4 male trs to xlr cable but never used it. I dont have a di box, at one gig the sound guy told me to plug into one, the two other times the mixing board was nearby so i just went with a regular cable.

Is this setup flawed?

 

Also, in the global settings under ins/outs, i have no clue what to set for these three settings for a full simulation direct to PA:

Main Out Level (Line i suppose?)

Amp Out Source (Main Out no? Does this setting even affect the left/mono main out jack?)

Volume Knob (Main Outs, Amp Out, or Both? I set my volume through the amp channel volume and boost it for my lead)

 

Thanks a lot for the help, yea i'm really bad at this ..lol

[SiCantwell]

That's the way I've done it for years. I use Main Out since I'm not sending to an amp (although even when I am I use Main Out because I like the sound better). I usually set the volume know to about 3/4 so I can boost it later if I want to. (Don't tell the sound man I said that! lol)