Hi all New owner of a HELIX floor unit here. I have been enjoying the unit for a few weeks now and have a few questions as I am about to start dabbling in snapshots. so as of now I have my unit set up like I did with my old hd500x. rhythm channel on one pre set high gain on another clean and lead etc etc etc. This use to work and I had gotten use to the slight delay in changing presets, with this floor unit its a bit more complicated for my preset switching. I need the ability to switch on and off effects and switch in-between presets during a song and I know snapshots can do this in a different manner then just switching a channel, I know it can activate and de activate amps and peddles etc. what I am trying to understand is this. If I want a rhythm clean and lead channel lets say, I understand that I have to make 3 snapshots and make sure all the effects and amps will fit in 1 preset due to dsp, what I don't understand is how I can switch the snapshots. like can I use the bottom 3 buttons to the right of the bank up bank down buttons for snapshot 1 2 and 3 and the rest for stomps? if so do I have the ability use 2 buttons one for clean and one for lead, and when I select the clean snapshot the foot controller that it was assigned to if pressed again could switch to my rhythm? I go to preset 1 all my snapshots are there. its already set to snapshot one (rhythm) I have all my stomp boxes set to other foot controllers other then the 2 that would switch to snapshot 2 and snapshot 3. lets say I need to go to lead (snapshot3) I press the button the lead snapshot is loaded but that button if pressed again will take me back to snapshot 1? is this possible?