Hi
I have a POD HD500 running in to a Line 6 DT25 head.
The HD500 is connected to the DT25 via the L6 link.
The unit has worked perfectly fine for a few months until recently. During a gig the sound just cut out completely. After swapping different cables (XLR, guitar etc) the sound came back.
When back home I tried to replicate the fault but everything worked fine once again.
A few weeks later the same thing happened again and then the display on pedal went blank, lit up but no information displayed.I un-plugged the pedal and went direct in to the amp, it worked fine.
The following night I had another gig, plugged my pedal in as normal and it worked fine!
I've just come to plug my pedal in again but first did a factory reset and flashed the firmware (successfully).
Now I'm getting no sound or control from my pedal to the amp. If I plug headphones in it's fine, if I go direct into the amp without the pedal it's fine.
I know straight away someone is going to say use a DMX XLR rather than standard but I honestly can't see this being the problem as the unit has worked fine with this XLR for months until now, I have also tried various other high quality XLR cables and none work.
DMX cables are hard to get hold of here without ordering on-line.
I can't use the warranty as I purchased the unit second hand and don't have proof of purchase.
Can anyone recommend a solution or at least how to open the unit up to see if there is a loose connection on the XLR output?
PLEASE HELP, I have a gig tomorrow!!!
Ian
