abteenz

I built this and it works. Ring is positive and sleeve is ground. However I believe that devices like the G10 receiver or THR30II do have some sort of other signaling going on with the transmitter while it's charging because the transmitter blinks red, orange and green while charging based on the percentage of the battery that it managed to charge. but the DIY is always green and you have to pull it on time. I guess it will reduce the life of the battery.

I built this and it works. Ring is positive and sleeve is ground. However I believe that devices like the G10 receiver or THR30II do have some sort of other signaling going on with the transmitter while it's charging because the transmitter blinks red, orange and green while charging based on the percentage of the battery that it managed to charge. but the DIY is always green and you have to pull it on time. I guess it will reduce the life of the battery.

I think it is for charging purposes.

Hi, I had a Powercab 112+ and recently got another one to have a stereo setup. I play a lot over backing tracks and I connect the powercab through USB to monitor the backing tracks. I got the AES/EBU cable and it routes the audio to the other Powercab from the one that is connected via USB but it can't distinguish between Input1 and USB audio and the second powercab doesn't play the Audio in Monitor mode and applies the speaker sim to it. Any way I can make the second one understand that this is the USB audio and not the INPUT1 audio? Long shot but worth a try. Thanks, Alan

Sorry for reviving this thread. Is there any way to use HX stomp for transport controls for Start (FA) and STOP (FB) command?

I have the same question. I want to buy one of the Kingsley tube preamps. I was wondering if it will work well with Powercab or not.

Hi, I'm trying to record what is coming out of the power cab from both inputs. My backing track is going through input 2 with flat settings and my guitar tone to input one with some cab settings. I can't seem to be abale to capture the backing track when trying to record with power cab usb interface. Any ideas? Thanks.

Follow this and You'd be able to control powercab with your HX stomp. You need a 5pin midi cable Powercab Plus MIDI Control with Helix MIDI - Helix - Line 6 Community