Jump to content

snakefuture

Members
  • Content Count

    12
  • Joined

  • Last visited

Community Reputation

2 Neutral

About snakefuture

  • Rank
    Just Startin'

Profile Information

  • Registered Products
    1
  1. I like to request the addition of a legacy amp section with some of the amp models from the Pod series.
  2. Essentialy the same problem here. Upto firmware version 2.70 everything worked perfect. I can update the Helix to firmware to 2.71 and 2.80. With those versions installed however, HX edit mentions no device connected and the application closes a few seconds after startup. Helix can be seen as a connected device under Windwos 8 though and audio is transfered under usb as well. Back to firmware 2.70 (only with the previous updater) HX edit can connect to Helix again.
  3. Id kindly like to request for the drum and bass patterns that were in the Spider Jam amplifier to be added to the Helix looper (in stereo).
  4. Id kindly like to request the following; - seperate left right signal mix functions for the fx loops 1/2 and 3/4. - the option for the delay effects to have the unaltered signal on one side (l/r) and the delayed signal on the other (l/r).
  5. Thank you for the video link. I just purchased these. Awesome full sounding patches at a very fair price. If you read this Mr. Delaune. Should you make a second set of patches. Could you then include a guitar transposed to bass patch like you did for the Boss Gt 10?
  6. snakefuture

    Helix FAQ

    I've tried connecting the Helix with the KPA creating a spdif effects loop between paths 1 & 2 but it produced strange ghost notes, Ive ended up connecting thus; Guitar --> guitar-input of the Helix --> input path 1 of the Helix set to guitar --> add pre amp effects on path 1 of the Helix --> path 1 out to XLR (main volume at 100%) --> XLR to alternative KPA input --> KPA spdif out --> input path 2 of the Helixset set to spdif in --> add post amp effects on path 2 of the Helix---> Helix 1/4 out. The output volume must be controlled by the KPA by marking the spdif link in the output menu of the KPA. Instead of the alternative input you could also use the front input of the KPA connecting this one to a send out of one of the fx loops of the Helix.set to instrument level. Id like to know if others succeeded attempting to create an all digital effectsloop from the Helix.
  7. On page 9 of the frequently asked questions page it is stated that HD500 connected through s/pdif with the Helix should work. Are you using genuine 75 Ohm s/pdif cables?
  8. Earlier comments by the Line 6 staff on another board suggested that the Helix could be slaved through s/pdif to the Kemper Profiling Amp, which itself can only be master.
  9. Could Line 6 make the Helix editor be compatible with Vista?
  10. Could Line 6 make the Helix editing software be compatible with Vista?
  11. snakefuture

    Helix FAQ

    I'd kindly like to ask. Can the Helix serve as a slave for other modellers with its digital connections?
×
×
  • Create New...