Search the Community
Showing results for tags 'amp effects'.
Found 2 results
-
I just got a HX Effects (firmware 3.71) and was excited to use the Ext Amp jack to control the Vibrato and Reverb effects of my Fender Deluxe Reverb. The amp uses a standard Fender 1/4" TRS dual footswitch to control the Vibrato and Reverb, and the footswitch included with the amp works fine. I actually have two Deluxe Reverbs, so I was hoping to get this going on both amps, one from each jack! However for the benefit of the first test, I tried a single amp, but had no luck! I set both pedal jacks to Amp mode in Global Settings > Prefs . I then connected one of them to my amp's footswitch jack with a TRS cable. The act of plugging in the TRS cable automatically turns on the Vibrato effect on the amp, and unplugging it turns the effect off. However there's just no way to program it to turn on and off with a command. There's also no way to control the reverb. I tried all the various settings for tips, ring, latch, etc. Nothing worked. Is this not possible?! -
Hello Everyone, I would like to know how the 4(5,6?) cable method* works with my Roland JC-22 AMP. I am new to all of this and I can't seem to find a good tutorial on this topic with my amp and the Helix floor. I want to get the same results as listed in the video tutorial listed here: But in stereo and be able to use my amps' chorus and reverb features. I am not sure how to connect the cables can someone here guide me how to make this happen? Please review the attached pictures of my warped understanding of the topic.
