Search the Community
Showing results for tags 'dirty'.
Found 2 results
-
There are a number of products available to clean pots and faders. One is 99% Isopropyl. DeOxit D5 or one of the other Cramolin brand pot cleaners works well. Also, Tri Chem makes/made a plastic safe contact cleaner for pots and there's Blue Shower by Techspray, L.P. Pull the plastic knobs up first. Spray onto a cotton swab and let it drip down the shaft. Work the pot to work in the cleaner. Canned air is good for blowing dust off and getting the cleaner to dry quickly. Do not use WD40, that will just gunk up over time.
-
Here is what I am looking for... I'd like to run two amps (one for clean tone, one for dirty tone w/ possible tube screamer), and be able to alternate between the two. Initially, I was thinking of running dual signal path for this, and then setting everything to the same switch (pressing the switch turns on dirty amp mod and tube screamer, and turns off clean amp and vice-versa), but I would need the unused path to be muted. I would assume the other way to do it (in the same patch) would be to run the amps in series. I am running a mono output, so I don't need stereo signals. I'd rather not have to set a different patch (in each block of 4) for each different tone in a song. And I would also be concerned about the delay between switching (the firehawk was a nightmare with this, I didn't keep it long...). I'm new to the PODHD world, and I've only been able to spend a few hours with the HD500x thus far. If anyone can give me good insight into how to set this up, I'd appreciate it. For a little more info, I'll be leaning towards the higher gain amps for my dirty tone (Fireball, Elektrik, etc.), and so far I'm liking the blackface for my cleans. My amp rig is a 6505 on an 212 orange cab with vintage 30s. I love my dirty tone from the amp, but I'm currently just using it as a power-amp to see what the HD can do. I find running it into the effect return on the head sounds much better than the instrument line in on the front.
