Jump to content

Search the Community

Showing results for tags 'go'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Community Support
    • Multi-Effects Units
    • Variax Instruments
    • Amplifiers
    • Computer Based Recording
    • Live Sound
    • Pedals/Controllers
    • Dream Rig - Line 6 Product Integration
  • General Discussion
    • Share your Settings
    • Line 6 Lounge

Categories

  • General FAQ
    • Operating System-specific Information
  • Tutorial Videos
  • Effects/Controllers
    • HELIX/HX
    • DL4 MkII Stompbox Modeler
    • FBV Controllers (MKII / 3)
    • M5
  • Recording
    • Helix Native
    • Metallurgy
    • Echo Farm/Amp Farm
    • POD Farm / POD Studio / TonePort
    • Computer Audio Set Up and Troubleshooting
  • Amplifiers
    • Catalyst
    • Spider V
    • Powercab
    • Spider IV
    • Spider Jam
  • POD
    • POD Go
    • POD HD X
    • Pocket POD
  • Guitars
    • JTV / Shuriken / Variax Standard / Workbench HD
  • Relay/XD-V Digital Wireless
  • Legacy Products
    • POD
    • Amps
    • Mobile Products
    • Effects and Controllers
    • AMPLIFi Series
    • Live Sound
    • Digital Wireless
    • 1st Gen Variax Guitars / Bass / Workbench
    • Software
    • Dream Rig
    • POD Studio / Tone Port / GuitarPort

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests


Registered Products

Found 2 results

  1. I just bought a pod go and was looking at which headphones to buy. Looking at the FAQ it says the headphone impedance output is 63 ohms?? That can't possibly be right can it? The helix floor is 12 ohms. Why is the pod go more than 5 times higher? Using the rule of 8, that would mean you need to use headphones with over 500 ohm load with the entry level pod. Did the FAQ mean we should use headphones with over 63 ohms? I'm really confused.
  2. The POD Go loads into the frozen bean silhouette with no progress upon starting. Went through installing go edit for the drivers, Line 6 updater, starting the POD in update mode with the updater in DXP-NFU, and using multiple computers and USB cables. No matter the combination, the firmware update fails. I get to where the PC says installing firmware update and the POD says updating, but the progress bar never even fills at all and the firmware update failed error always follows.
×
×
  • Create New...