Search the Community

Hello folks, They call me GEDD! I am fairly new to modeling. Got myself a helix floor unit a couple of months back. I have been expanding my knowledge in and around properly utilizing it. In this pursuit of creating my desired tones below are some questions i have for you. QUESTION 1: How do you choose a cab to compliment the tone that you have already achieved in the signal chain pre adding a CAB? QUESTION 2: Looking at the signal chain from every point of view (technical or otherwise) is a cab "mandatory" to be added in a signal chain if the you have already achieved the desired tone? I hope to get different takes on how each of you approach this part of the signal chain and what is the factual / feel reason that prompts you make the cab choices you make. I would also appreciate any tips or advise you have to offer. Thanks for taking the time in reading this post and contributing. Cheers - GEDD I have attached a custom tone file in which i have already achieved the tone i am looking for. Feel free to take a look. GRAM-GSG (EX).hlx

Hello all, 1st time post and considering getting an HX Stomp. I’ve read through some of the forums and read some reviews and I am really liking what I’ve seen/read. My question is though, can you have 2 amp blocks on one preset? For example, say for a clean I want to use a Fender block, but for my crunch/dirty tone can I use a Marshall block and be able to switch between the 2 via one of the 3 foot switches. I apologize if this has been discussed somewhere else, but I have not seen it. Thanks in advance for any input.

Just thought I would throw this out there since the Helix HX Stomp is brand new and the Firehawk 1500 is oft mentioned as an FRFR option. I have the Firehawk 1500 and have the Helix Stomp on the way (hopefully) and I am still a little fuzzy about how to complete the connections from the Stomp which is a complete but slightly limited I/Os and the Firehawk, which has a myriad of I/Os which effect the amps speaker outputs. I have sent inquiries directly through L6 support tickets and I have some confirmation concerning these hookups, but I do not know exactly which I/Os to use on the new Helix Stomp to get the W/D/W response from the amp. I'm just looking for some clarification since everything published on this so far has not mentioned either the Stomp specifically or the Firehawk 1500 specifically. Below is the question I posed to L6 in the support ticket section and their response. Me: "Ok, simple question. I assume that since the Firehawk is a stereo amp and the Monitor inputs are L/R, that the 4 cable method would now be a 5 cable method with the Helix stomp L/R outputs in the back going to the L/R monitor in on the Firehawk and that the guitar would then go into the Mono input in and then out from the side panel send to the guitar input of the amp. Would this activate all the speakers on the Firehawk and give a W/D/W sound from the amp?" L6: " You are correct, you are free to utilize the stereo inputs on the back of the Firehawk making this a 5 cable method of sorts. You are also correct as running an input to these monitor ins will be a dry, unprocessed signal and will only take the modeling from the HX Stomp itself." As you can tell, informative, but not specific. Hopefully, I can get some input that will help anyone that happens to already own the Firehawk 1500 and is considering upgrading the preset capbility to that of the Helix via the aquistition of the Stomp. It would be really helpful if anyone could include the diagrams since those in the new Stomp manual do not mention the Firehawk 1500 connection option.