Search the Community
Showing results for tags 'pair'.
Found 2 results
-
All 4 tone lights (or ABCD lights on the FX100) flashing is 'recovery mode'. It is the intended behavior after a failed update. If you come across this mode, you must attempt to update the AMPLIFi again. Power down your AMPLIFi. When updating via PC, please connect the USB cable and make sure to boot the unit while holding Tone+Tap (amp, TT) or A+C (FX100) to put your AMPLIFi into Update Mode. Run the Line 6 Updater program found at www.Line6.com/software. For a guide, please refer to http://line6.com/support/page/kb/_/amplifi-products/ampl/how-to-update-amplifi-with-a-pc-r701. If you still get failed updates from the Line 6 Updater, try another USB cable and port as well as another computer When updating via an iOS device, Bluetooth works in recovery mode, but the pairing from before the failed update is not maintained. You must press the Bluetooth button and pair again from the smart device's Bluetooth menu. You can then proceed with the update.
-
As the title says...I have a nice pair of Bluetooth headphones and would like to know if their is a way to pair them to the Amplifi TT. I was hoping this might be possible as the TT can stream to a receiver or other audio device that can receive a bluetooth audio stream. I just don't know how to pair them as neither has an interface that would allow me to put in a pin? My fear is I'll have to purchase something like this (Click here).
