Search the Community
Showing results for tags 'speaker simulation'.
Found 1 result
-
I apologize if this was asked previously elsewhere. I tried perusing the manuals and searching the forums... For the last 4 years, I have been using Guitar Rig with Rig Kontrol live. Honestly, I might still be a happy user if NI would keep their products up-to-date and not discontinue their hardware. :angry: I can't do a live show anymore without experiencing bad audio drop-outs and worse. Time to ditch and look elsewhere... One of the cool things I was able to do with GR, however, was route speaker simulation (cab sim, etc.) to ONLY one side of the outputs. My common setup was to run the output with NO cab sim to my on-stage amp, and the output with the cab sim ON to the DI/PA system. The tones were just a little off from each other, but my stage amp has V30's, and so I'd run the V30 cab sim for the house line, and with a little EQ, I was a pretty happy camper. This became the better option, rather than A) Mic'ing the stage cab for the house feed (not a fan), and B] Running the cab sim ON to my amp signal (Redundant yuck.), or C) Using NO cab sim (horrible shrill line out). So obviously, that's my question. Can you, somehow, route the outputs on the HD500X in such a way where the speaker simulation is running to, say, the Balanced XLR output(s) - meanwhile the 1/4" amp outputs disengage any cab sim? Or...is there another option/configuration I'm not aware of that addresses this issue? Thanks for the help!
