dudluu Posted February 2, 2018 Share Posted February 2, 2018 Hi y'all In all patches in the firehawk when I move the volume pedal it sets the "drive" of the amp setting to another position than programmed.First I thought the "drive" is assigned to be tweaked by the pedal, but as far as I know you can not tweak amp settings with the pedal.I calbirated the volume pedal but this did not help at all. Example: "drive" is programmed to 80%. Sounds nice. Now I move the pedal to adjust the volume and the volume is controlled nicely, but also the "drive" parameter jumps to somewhere around 50%. When I move the pedal again the "drive" never goes back, it moves between 40 and 50%. No chance to bring it back up to its initial setting. Firmware version. 1.30 Anybody the same problem? Solutions? Thanks! Quote Link to comment Share on other sites More sharing options...
silverhead Posted February 2, 2018 Share Posted February 2, 2018 I wasn't aware that the pedal could not be assigned to amp parameters. Are you sure about that? Have you checked the pedal assignment using the Firehawk app? It certainly sounds like it is assigned to the amp Drive parameter, and set to a mid-range sweep. Quote Link to comment Share on other sites More sharing options...
jneely77 Posted February 8, 2019 Share Posted February 8, 2019 I'm having this exact same issue, only mine cuts the amp drive to 1% whenever I use the volume pedal. Did a factory reset and I'm still having the problem. Quote Link to comment Share on other sites More sharing options...
Kilrahi Posted February 9, 2019 Share Posted February 9, 2019 All of this is very confusing because you're not supposed to be able to assign the pedal to amp parameters. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.