jdolby Posted October 22, 2018 Share Posted October 22, 2018 I'm using Helix (floor) with my 212 cabinet, powered by a Carvin DCM 150 power amp. A typical patch would consist of me going through a distortion pedal and maybe a modulation effect before the amp sim, then delay and reverb after the amp sim. The signal is sent to the 1/4" output jacks. What do I need to do to my patch to keep the above _AND_ send an FRFR signal to the mixing desk? Quote Link to comment Share on other sites More sharing options...
j_hotch Posted October 22, 2018 Share Posted October 22, 2018 Make sure your output block is set to Multi and you should get the same signal out of 1/4 in and XLR outputs. Send one to your amp and the other to your desk. Voila! Quote Link to comment Share on other sites More sharing options...
aaronlyon Posted October 22, 2018 Share Posted October 22, 2018 I've been using my Helix Floor in the way you describe, @jdolby, for the past year, and it works great. In addition to the 1/4 output that goes to my SS amp and guitar speaker cab, my Helix patch is split to B path after the amp sim, and I add a cabinet+mic block, then that goes out via the XLR to the house PA. The XLR out is fixed volume, but the 1/4 out is controlled by the Volume knob, so I can adjust my on-stage volume, without changing the PA volume. 1 Quote Link to comment Share on other sites More sharing options...
jdolby Posted October 26, 2018 Author Share Posted October 26, 2018 Thanks guys. After playing around with the unit I split the signal after all my effects and added a speaker. From there I sent the signal to 2B and changed the output to XLR (frfr). Works great! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.