hdoran Posted March 6, 2021 Share Posted March 6, 2021 I made an instruction video showing how to use the FCB 1010 MIDI Foot Controller with the HX Stomp. Hope it helps others. https://youtu.be/c2NRFl65lTs 1 Quote Link to comment Share on other sites More sharing options...
HonestOpinion Posted March 7, 2021 Share Posted March 7, 2021 8 hours ago, hdoran said: I made an instruction video showing how to use the FCB 1010 MIDI Foot Controller with the HX Stomp. Hope it helps others. https://youtu.be/c2NRFl65lTs Great video! I'm sure another one on setting up the FCB1010 expression pedals would be equally welcome. Btw, you may already be aware of it and just wanted to demonstrate how to do this with no additional software/hardware required but included are some additional FCB1010 resources below that can greatly streamline and simplify the programming process. Haven't used the FCB1010 with the HX Stomp but I will mention my one caveat. Using the FCB1010 with other devices can allow you to get switching working reliably but it can be tricky to have the FCB1010's pedal LEDs properly reflect the state(e.g. is a block on or off) of the connected device. Particularly for more complex switching operations. This freeware FCB1010 Editor makes programming the FCB1010 much easier and requires a lot fewer programming pedal presses. http://www.mtnsys.com/?path=faq-fcb/PCEditor.htm%3f There is also the UNO2 EPROM upgrade chip(very simple to swap in, no soldering required) for users who want even more control over the FCB1010. They offer an editor as well although it is not free. You do get a free editor if you purchase the EPROM. https://www.fcb1010.eu/ There is also the "Tiny Box" if you want to have even more advanced control over the FCB1010. https://shop.tinybox.rocks/ Update: See rd2rk's post below as that version of the EPROM is cheaper and may be all that many people need. I should have mentioned that one as well. 1 Quote Link to comment Share on other sites More sharing options...
rd2rk Posted March 7, 2021 Share Posted March 7, 2021 I'll throw in that the same website where you get the UNO2 chip also sells the UNO 1.0.4 chip and it's GUI editor. This chip falls between the very limited stock chip with Mtnsys/Ed Dixon GUI editor and the fully programmable UNO2 with actual code editor. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.