DL4 MKii Looper will not respond to midi notes

[salty09]

I cannot seem to get the dl4 mkii to respond to the midi notes listed in the users guide when I send them from my morningstar mc6 pro.

 

I found another user asking about the same thing on the morningstar site with no resolve posted as of yet.  

https://forum.morningstar.io/t/sending-midi-note-on-messages-to-the-dl4/4316/2

 

I have tried moving the octave to every possibly position and cannot get the looper to respond to any of the commands on any note. 

 

I am hoping to get this to work, because it simplifies the looper control from the mc6 side.  If I end up having to go the cc# route it will take more switches.

 

Any one got it to work using the midi notes they defined in the guide? 

 

Thanks! 

[jiml6]

On 6/28/2023 at 3:24 PM, salty09 said:

I cannot seem to get the dl4 mkii to respond to the midi notes listed in the users guide when I send them from my morningstar mc6 pro.

 

I found another user asking about the same thing on the morningstar site with no resolve posted as of yet.  

https://forum.morningstar.io/t/sending-midi-note-on-messages-to-the-dl4/4316/2

 

I have tried moving the octave to every possibly position and cannot get the looper to respond to any of the commands on any note. 

 

I am hoping to get this to work, because it simplifies the looper control from the mc6 side.  If I end up having to go the cc# route it will take more switches.

 

Any one got it to work using the midi notes they defined in the guide? 

 

Thanks! 

I found this in the manual, Line 6 follows Yamaha’s MIDI note spec, where middle C is “C3” (unlike some other gear manufacturers that prefer to say middle C is “C4”). Maybe try using C0 instead of C-1.