pitowilson Posted June 9, 2013 Share Posted June 9, 2013 Hello ! First of: sorry for my english !!! But I hope you will understand my problem :) I have recorded through Nuendo (used ux 1 as sound card without any simulation) when suddenly everything froze. I rebooted computer a turned pod farm on again a there was no input signal and no output sound. LED was green everything seems allright but no I/O signal. I tried reboot more time and plug to other usb but still lollipop. Can you help with that? thanx Quote Link to comment Share on other sites More sharing options...
Triryche Posted June 10, 2013 Share Posted June 10, 2013 Run the Monkey and make sure you have green ticks for drivers/flash mem, ect... Also, make sure you are selecting Line6 ASIO as your device in Nuendo. Do you have an older red-faced Toneport or a newer black-faced POD Studio? Quote Link to comment Share on other sites More sharing options...
pitowilson Posted June 10, 2013 Author Share Posted June 10, 2013 Hi, I have the newer versiom, I ran the monkey the pod farm 2 wasn´t in green but I updated it , but still no sound. I was in the middle of recording session in nuendo so the I/O in ASIO was set good. Its no sound or input signal just trough the UX. Quote Link to comment Share on other sites More sharing options...
pitowilson Posted June 15, 2013 Author Share Posted June 15, 2013 Run the Monkey and make sure you have green ticks for drivers/flash mem, ect... Also, make sure you are selecting Line6 ASIO as your device in Nuendo. Do you have an older red-faced Toneport or a newer black-faced POD Studio? Hi, I have the newer versiom, I ran the monkey the pod farm 2 wasn´t in green but I updated it , but still no sound. I was in the middle of recording session in nuendo so the I/O in ASIO was set good. Its no sound or input signal just trough the UX. Quote Link to comment Share on other sites More sharing options...
silverhead Posted June 15, 2013 Share Posted June 15, 2013 I would run Line 6 monkey and reinstall the UX1 driver and firmware. Quote Link to comment Share on other sites More sharing options...
pitowilson Posted June 16, 2013 Author Share Posted June 16, 2013 I would run Line 6 monkey and reinstall the UX1 driver and firmware. I already did it but its still same. I tried install it on 3 different PC but stil no sound Quote Link to comment Share on other sites More sharing options...
silverhead Posted June 16, 2013 Share Posted June 16, 2013 I suggest you open a support ticket to work directly with Line 6 tech support. http://line6.com/support/tickets/add.html Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.