Sideshowqaz

I just bought a second L2T and L3s to link with my existing L2T....new L2T appears to exhibit this problem...accoustic channel is cracking-up so bad it is not usable for performance - needless to say, extremely frustrating. Does the L3T also show the same defect?....if necessary, will buy a pair of L3T's rather than lose out on any more gigs.

Axus73 - 500 master volume works, but I'm only connected to the L2T via balanced out...I abandoned the use of L6 Link....loss of local contrl of master volume (at the HD500) was one problem, but also, L6 Link seems to bypass the mixer altogether, affecting independent use of the Ch1 acoustic modeler for a parallel PZ bridge pick-up input in my config. Once I dumped the L6 link, normal HD500 operations returned. Tks - Matt

Axus73 - Also new to the HD 500X into an L2T...I too was concerned I might be limiting by running the 500 balanced out into Ch2 of the mixer....green light above the Gain cntrol atbalmost any level....went back, reread the manual....seems green is normal, i.e., "signal present"...flashes red if limiting.......I switched-in the -20dB pad for a little extra insurance, but appear to be able to run the 500 master at 12:00....no orange / red... Appreciate anyone's thoughts on this.. - Matt

Silverhead - how about running HD 500X balanced out into a mixer channel with the -20db pad enabled....I seem to be able to hit it pretty hard with no limiting indicated, get some benefit from mixer EQ.....thoughts?....tks - Matt

Wahwah - rookie here, but discovered similar restrictions wrt the L6 Link/POD connection....restrictions were also confirmed via Line6 telephone spt....net for me is to go studio direct for the POD (feeding the L2T ch2 with XLR together with a second XLR connection as ch1 for acoustic), use the POD and L2T mixer for signal shaping, EQ...in your case, I would probably do same, but patch the adjacent soundman via summed (balanced) directly out of the L2T backpanel - Matt