Having a problem with amp control when switching between presets. After saving a preset with an ext amp toggle to 'on', when switching to that preset the amp is not toggled, even though the switch indicates on. Using a crate shockwave amp if that matters. I can switch back and forth between another snapshot that is toggled off, then it works as expected. I usually prefer to have my presets default to the clean channel, for this amp that's an 'on' toggle. Any suggestions would be extremely helpful!
Steps to recreate:
1. Save 2 snapshots within a preset, Snapshot 1 with ext amp toggled on, Snapshot 2 with ext amp toggled off. Snapshot 1 is saved as the active Snapshot.
2. Switch back to that preset:
Expected behavior - Snapshot 1 is selected, ext amp toggled on, and amp toggles to the 'on' state, in my case a clean channel.
Observed behavior - Snapshot 1 is selected, the footswitch 'ext amp' is toggled on, but the amp is not toggled, and is on the lead channel. Selecting Snapshot 2 and then Snapshot 1 will toggle the amp, or switching the footswitch 'ext amp' off and back on.
At first this could seem to be a bit of a minor thing, but when you have the clean channel setup going thru the lead channel instead, you can potentially get some very...interesting but undesired sounds and feedback while you're frantically trying to get it switched :p.
Thanks!