Jump to content

DimSam

Members
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

1 Neutral

About DimSam

  • Rank
    Just Startin'

Profile Information

  • Registered Products
    1

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. DimSam

    2.80.1 hotfix not installing

    Solved!...factory restore didn't help.I just kept going back to previous versions and then directly to 2.80.1 and it finally worked. Thanks to everyone who replied.
  2. DimSam

    2.80.1 hotfix not installing

    Already done all of that.The problem lies with the fact that although upgrading to 2.80 was flawless,now the screens are blank so when I hold down the > button and boot it,nothing happens.Blank screens.
  3. DimSam

    2.80.1 hotfix not installing

    This is what I'm getting.The hxfx screens are all blank instead of saying 'updating' .If I try booting with failsafe mode,I get the same.That's blank screens.Updating to 2.80 was a breeze.
  4. I'm having a weird issue.I updated succesfully to 2.80 but when I try to update to 2.80.1 , I get this ''HX Effects Firmware Update Suspended HX Effects did not reset instructing it to enter DFU mode. 1.Click 'OK', then cycle power the unit.'' and if i try to enter by holding down the ''>'' button the hx effects screens are all blank.
  5. DimSam

    No output after 2.71 update

    I have my guitar connected in the input and the output goes to the amp.When the unit is off,the signal goes through.So there is the dry/bypassed signal from the guitar.When I switch the HX effects on to use my presets,it has no output. Reverting to 2.70 it works as normal when on with all my presets. I backed up all my presets and installed the 2.71 again.I did a factory restore and the unit works as normal.When I try to restore the backed up presets there is no output signal again. It is all very weird.
  6. DimSam

    No output after 2.71 update

    I updated to 2.71 and there's no sound coming from the unit.If i switch it off the sound comes back.Switch on again and no output. Reverted back to 2.70 and all's fine.Is anyone else experiencing this after the last update?
×