Jump to content
Sign in to follow this  
AdInfinitum

New Workbench Software Borked My Jtv

Recommended Posts

I updated workbench and the new JTV HD firmware. No problem, except, as advertised, the new firmware wiped my presets. Ok, no big deal, I have a cheat sheet with all the old alternate tunings. I start updating and try to save a simple Eb tuned patch to Custom 1. The patch works in the Eb tuning, but when i itried to save the patch, Workbench then gives me an error saying it can't save the patch. Then the JTV goes dead - no power to the modeling section. Battery shows no lights.. I remove the battery, let it sit and recharge it (it was already at full charge), the JTV finally gets back power. I try again to save the patch, same thing, but this time the unit is DEAD - the variax board is shot - no power and battery doesn't show any lights. Any ideas? Anyone else having problems saving new patches?

 

I'm running a iMac, snow leopard. Monkey updated everything to latest versions.

Share this post


Link to post
Share on other sites

Line 6 site Downloads page. It's a freebie for JTV, Standard and Shuriken, with Flash v2.00 and higher. 

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...