Emmett_P Posted July 6, 2016 Share Posted July 6, 2016 Hi, I am with a company designing a custom midi controller that we wanted to have work with the M9. We are using Arduino to implement the controller. I have the looper doing play/stop and record via midi, all of which work great. When I tried to implement overdubbing, the M9 does not respond. I am sending a midi control change message with controller number 50 and a value of 0 on channel 1. I have tested this by sending the midi message to Abelton, which recieves it correctly and verifies this is what is being sent. I have also tried implementing it via Arduino's midi library and via their serial.write sending the message manually. I checked the midi input in setup as well, and have tried it both as channel 1 and omni. Another weird thing is that when the M9 is in record mode and receives this message it goes into playing while overdubbing, but once the M9 is playing the message does nothing. Really unsure what is wrong here unless our M9 is just defective, I have exhausted every other factor of error I can think of. I am going off the midi controls listed in the manual here: http://line6.com/data/6/0a060b316ac34f0593fca717b/application/pdf/M9%20Advanced%20Guide%20-%20English%20(%20Rev%20A%20).pdf We are on a deadline to have this working so any help is very much appreciated. Thanks! Quote Link to comment Share on other sites More sharing options...
stkt78 Posted September 15, 2016 Share Posted September 15, 2016 I have the same problem :( Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.