cpatchett 0 Posted December 23, 2018 Hi. I just bought a used JTV-59 that is in mint condition except the 3-way selector switch selects the same thing in the outer and middle positions (outer meaning away from the pickups). This is true regardless of whether I'm using the magnetic pickups or the modeling options, and is the same regardless of which selection switch option is active (i.e., from pushing down the tuning knob). I've also experienced the middle position being dead once; wiggling it restored the (incorrect) selection. Based on this I'm guessing either the switch is bad or there's a bad solder connection. I've searched through the forums and seen lots of issues where the selector switch works for the magnetic pickups but not the modeling options or vice-versa, but haven't seen this particular problem posted. Any ideas? Quote Share this post Link to post Share on other sites
cruisinon2 2,532 Posted December 23, 2018 Sounds like you need a new switch... Quote Share this post Link to post Share on other sites
psarkissian 354 Posted December 26, 2018 Intermittent solder point(s) on the switch assembly. Quote Share this post Link to post Share on other sites