kimsharp Posted July 19, 2019 Share Posted July 19, 2019 I updated my helix to 2.80. Now the two Line 6 L3M speakers connected via L6 Link aren't working. Quote Link to comment Share on other sites More sharing options...
xmacvicar Posted July 19, 2019 Share Posted July 19, 2019 Global settings are reset during the update, is it possible your output settings are not done properly? 1 Quote Link to comment Share on other sites More sharing options...
kimsharp Posted July 19, 2019 Author Share Posted July 19, 2019 I checked that, but no luck. Quote Link to comment Share on other sites More sharing options...
kimsharp Posted July 19, 2019 Author Share Posted July 19, 2019 I went back and checked the Volume knob. It was set to multi, I normally set it to only control the XLR output so when I feed the house I can control the level. Thanks, Xmacvicar. Quote Link to comment Share on other sites More sharing options...
xmacvicar Posted July 19, 2019 Share Posted July 19, 2019 1 minute ago, kimsharp said: I went back and checked the Volume knob. It was set to multi, I normally set it to only control the XLR output so when I feed the house I can control the level. Thanks, Xmacvicar. Interesting. I am glad its working, however, if it was set to multi, this should have also controlled the signal over digital L6 Link, so that kind of doesn't make sense? Scratching my head there haha Quote Link to comment Share on other sites More sharing options...
jpdennis Posted July 19, 2019 Share Posted July 19, 2019 42 minutes ago, kimsharp said: I went back and checked the Volume knob. It was set to multi, I normally set it to only control the XLR output so when I feed the house I can control the level. Thanks, Xmacvicar. Good catch. I find using Multi quiets my presets as I go 4CM at line level out to all then XLR is the only output the volume pot controls. 42 minutes ago, xmacvicar said: Interesting. I am glad its working, however, if it was set to multi, this should have also controlled the signal over digital L6 Link, so that kind of doesn't make sense? Scratching my head there haha I scratched my head as well when I was setting up my 4CM for stage and XLR out to PA path. I haven't delved into the reasoning but with 2.80.0 installed I am revisiting everything Quote Link to comment Share on other sites More sharing options...
HonestOpinion Posted July 19, 2019 Share Posted July 19, 2019 58 minutes ago, xmacvicar said: Interesting. I am glad its working, however, if it was set to multi, this should have also controlled the signal over digital L6 Link, so that kind of doesn't make sense? Scratching my head there haha I get what you're saying but it makes sense if the outputs your monitor was plugged into before the update were not controlled by the Volume knob. When the volume knob does not control a set of outputs those outputs default to full volume (as if the volume knob were at max). So, depending on how a preset is gain staged it may no longer be loud enough if it is now going by the Volume knob. Quote Link to comment Share on other sites More sharing options...
kimsharp Posted August 25, 2019 Author Share Posted August 25, 2019 I leave the volume knob at zero unless I'm playing live. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.