innovine Posted February 26, 2014 Share Posted February 26, 2014 Hi, I noticed recently that HD500 Edit keeps toggling the amp model off every time I do something... for instance, if I drag an effect to move it from one position to another, when I release it, there is a quiet crackle from the amp, and the amp model turns off. I can turn it back on just fine, but it'll turn it off again next time I move a pedal/effect.. I'm using HD500 with my pod 500hd while it's connected to my DT25 via line6 link, which is NOT currently connected via midi. This problem only came up recently and I'm damned if I can think of what I might have done to cause it... Quote Link to comment Share on other sites More sharing options...
radatats Posted February 26, 2014 Share Posted February 26, 2014 yeah this is a consistent occurence when I have my DT connected too. I am not sure what causes it but it does not happen without the DT connected... Quote Link to comment Share on other sites More sharing options...
Brazzy Posted February 26, 2014 Share Posted February 26, 2014 Same thing happened to me a few times, then I adjusted my method of building and using patches. The noise can surprise you enough to make ya JUMP. Quote Link to comment Share on other sites More sharing options...
innovine Posted February 26, 2014 Author Share Posted February 26, 2014 *facepalm* Quote Link to comment Share on other sites More sharing options...
sonic Posted February 27, 2014 Share Posted February 27, 2014 Same thing here... It happens when I start a patch from scratch and the selected amp switches off as I move an effect. The workaround is to save the patch intermediate. Also when I had a volume pedal set to go from 70% to 100% and I switched to another patch to check the levels, when I came back the volume pedal was reset to 0%. Again saving the patch first resolved the issue. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.