vincetorr Posted September 13, 2023 Share Posted September 13, 2023 Hello everyone, im using the 4 cable method to connect my PodGo to my ampli Bugera 333. It sounds amazing pre fxloop, (i mean distortion, noise gate...) but i have no modulation. No reverb, no delay. I already checked cables...they are in the right spot. Any suggestions will be great. Quote Link to comment Share on other sites More sharing options...
silverhead Posted September 14, 2023 Share Posted September 14, 2023 Please describe your cabling setup exactly. Sometimes users believe they are properly connected when in fact they are not. Does that amp have an FX Loop? Also, where in the signal chain are your modulation, delay, reverb etc. blocks? Pre or post FX Loop block? Quote Link to comment Share on other sites More sharing options...
rarellano Posted September 15, 2023 Share Posted September 15, 2023 I have a similar issue. And I've tried to reproduce a "real chain", so: Guitar to POD Go input POD Go Wah, OD, etc. POD Go amp & cab disabled POD Go FX Loop enabled POD Go send Amp input Amp pre Amp send POD Go return (setting like return, no like aux) POD Go mods, delays and reverbs POD Go main out L Amp return And everything between POD Go return and POD Go main out L (mods, delays and reverbs) it doesn´t sound. Quote Link to comment Share on other sites More sharing options...
voxman55 Posted September 15, 2023 Share Posted September 15, 2023 Have you turned the FX loop on? 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.