Mike1225 Posted July 5 Share Posted July 5 All of a sudden, when I activate the tuner it fails to mute the signal to amp (though tuner comes on) Note: I'm using the LT as an effects processor and amp controller 4CM with Soldano 30 (I guess 5CM with amp switching). I've been using this rig with very minimal changes other than updating firmware. Haven't changed a thing in months so this just appeared. I believe it's sending the signal to the effects loop return bypassing effects on the unit. Appreciate any ideas. Thank you! Quote Link to comment Share on other sites More sharing options...
silverhead Posted July 5 Share Posted July 5 You don’t mention this. I assume you are aware of it but just in case… Make sure the Tuner Settings have the Tuner Out parameter set to Mute. Quote Link to comment Share on other sites More sharing options...
Mike1225 Posted July 5 Author Share Posted July 5 Ha! I didn't even know there was a setting for that. Yeh that fixed it. Must of somehow knocked it my foot or something when the tuner was on. Thank you. Quote Link to comment Share on other sites More sharing options...
theElevators Posted July 6 Share Posted July 6 That's the danger of not being able to lock your settings. I managed to change the tuner calibration to 436 instead of 440, and didn't even realize it for a few months. When in doubt, click on all the knobs--that will restore the values to the defaults. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.