Leaderboard

Digital Igloo has confirmed Pod Go will definitely be getting a big update. I suspect as per v2.0 Line 6 will be doing a 2 for 1 combined update again to incorporate the last two Helix updates (subject to dsp limitations). I can't think it will take too much longer so fingers crossed.

Rotary Encoder for HX Stomp / Helix - FOUND!

As Helix now has the 2203 model, it's anticipated that the next Pod Go firmware upgrade will have this as its not using an excessive amount of DSP and should fit into Pod Go. Users were hoping it might be released by Christmas this year as its been over a year since v2.0 but nothing has yet been announced. Hopefully it's not too far away.

Yes I got my pod go a few weeks after it was released and when I got it I was showing my brother some of the features and when I went to show him the wah that’s when I noticed it was real hard to engage toe switch and that’s when I went to see if it had some kind of pedal cal settings and I found in one of the settings/menus you could set the sensitivity by pressing down on toe switch and fine tune it with up and values. And it had an overall pedal cal option. After I did update a few nights ago I noticed toe switch was too easy to press .I’m usually Good at troubleshooting most problems and I’ve scoured the net looking for any info and can’t find anything not even a mention on a old forum or anything I wish someone could confirm this cause I’m starting to think I’m going crazy. Anyway I love this new pod I’ve actually been playin it more than my axe3