Search the Community
Showing results for tags 'headphones out'.
Hi there! I have Spider V 30 MKII and I connected it to my PC I want to play on guitar and hear it in my headphones that connected to PC and mute my amp But I forget how to do it and I don’t hear anything from headphones but amp sounds :( What I need to do? P.S. Sorry for my English and for such a long text, hope for the answer
Hello. I was wondering if any of you have experienced any issues with the headphone output of the Helix LT or Helix Floor? I have an Helix LT connected as an audio interface to my Windows 10 laptop. I only use headphones and like to jam along with YouTube and guitar pro and recently when I listen to a preset through my headphones connected to the output jack of my Helix LT, the panning/volume is all wonky and is not balanced with the right side noticeably louder than the left. The issue is across all my patches including factory and user). The issue seems to be volume related, if you crank up the amp or add a distortion block it seems to pan harder to the right and becomes very off putting. If you turn the volume knob below 12 o’clock the panning balances better, turn the volume knob up to 3 o’clock or to full then panning is almost hard right and I can hardly hear anything from the left as if you’ve have duff headphones. As a temporary work around I have to pan the output block at the end the chain by at least 30% to the left to balance the sound. I've tried different 1/4 inch adapters and different headphones, I have some in ear monitors and a pair of Beyerdynamic DT770 pro 250 ohm and the issue persists. I have even sought a second opinion from my wife who agrees there is Definitely a panning/volume issue. There is no problems when listening to music and videos from YouTube etc. It only affects my guitar patches. Also, this seemingly started happening out of nowhere. I do not recall making any changes to global settings, but perhaps that is where the problem is? I am updated to firmware version 2.92 and have been since it was released. Out of desperation I have completed a factory reset and even rolled back the firmware to 2.8 and reinstalled 2.92 with no joy and I am now worried it may be a hardware issue. Everything has been working fine until now. If anybody could help me figure this out, I would really appreciate it! Thank you.
FOR LIVE STAGE, I would like to use the headphone out ( amplifi 150) and plug into a pa mixer , so I can get into the band mix. With 5 speakers ,it's not easy to mike the amp unless I use multiple mics. I'm assuming that the headphone out signal encompasses all the speakers!,, Some input would be appreciated. Thanks
Was playing around recording my Spider Jam by injecting the mic input on my laptop (Vaio VGN AR630E) with headphone out from the amp. With minimal tweaking I had the hottest signal I could stream into Ableton Live, there is a noise floor, keep in mind I'm using the insane (red) model. Sounded pretty good, but the amp itself sounds even waaaay better, lol. Also, I was monitoring with latency from the laptop speakers (according to Ableton Live 8.2.8 > 41.3 ms's worth) I was not using ASIO I was using MME/DirectX driver and Sigma Tel High Definition Audio CODEC input device. Suppose if I play with the amp settings I could get less noise floor.