grdGo33 Posted July 21, 2020 Share Posted July 21, 2020 Sigh... I just tried to update the firmware of my unit and now it's not booting up... Everything was going fine until it said "Error", turn off the Go power switch, etc., and after turning off the Go power switch, it doesn't boot up anymore... When I power on the unit normally I just get the Pod logo and nothing happens When I connect the USB cable, nothing happens If I boot up the unit in 'update mode' (Page > button), I can hear the Windows USB device connected sound, but nothing happens. If I launch Pod Go Edit, it says "no device connected". If I replug the USB cable, I get a device connected sound, but nothing happens in POD Go Edit, still "no device connected". I tried a different USB cable, different port, same thing. I tried "start with the POD Go turned off, then flip on the power switch while holding down for 5-8 seconds: - C & D - Factory Restore (Restores all factory settings)", but nothing happens. Stuck at Pod Go logo. :\ What can I do?  ok I had found this article https://line6.com/support/page/kb/pod/pod-go/pod-go-failed-update-recovery-r944/ and it mentioned the Line 6 updater, it doesn't reference the Pod Go Edit 'updater', it refers to another application, trying that one... Fingers crossed... Quote Link to comment Share on other sites More sharing options...
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.