Leaderboard

I have set the scribble stripe brightness to 100 in Global Settings, but it is nowhere as bright as the Helix Floor. I sometimes play outside at festivals (sunny) and this would be a big issue for me. Am I missing something?

I've already confronted this situation and had to repeatedly lean down to see my snapshots. I suggested that Line 6 include the Performance Mode for Stadium XL in a future firmware update to get around this, as replacing all the OLEDs with LCDs is probably not viable. I did go through and organize my LED foot switch rings by color but those are also less bright than on the original Helix Floor. I have an upcoming national tour in June, and I'm even considering selling the Stadium XL and getting the smaller Stadium. That's how serious this problem is.

I’ve noticed that too, and yes it does make sense. Maybe a good feature request?

I had Claude (Anthropic's LLM) look at the manual and it pulled out these shortcuts: POD Express Bass - Key Combination Shortcuts Amp Parameter Editing Hold ALT + Turn COMP knob → Adjust amp GAIN Hold ALT + Turn SYNTH knob → Adjust amp MID Hold ALT + Turn DIST knob → Adjust amp BASS Hold ALT + Turn MOD DELAY knob → Adjust amp TREBLE Hold ALT + Turn AMP encoder → Adjust amp CH VOL (Channel Volume) Master Volume & Hi-Mid/Additional Parameters Hold ALT + Hold TAP + Turn DIST knob → Adjust Master Volume Hold ALT + Hold TAP + Turn MOD DELAY knob → Adjust Hi-Mid parameter For Grit amp: Adjusts Midrange Frequency (220 Hz, 800 Hz, or 3000 Hz) For Vintage amp: Adjusts Bright switch (On/Off) For Studio amp: Adjusts Midrange Frequency (150 Hz to 1000 Hz) Cab Selection Hold ALT + Hold TAP + Turn AMP encoder → Select/change Cab model Noise Gate Parameters Hold ALT + Hold TAP + Turn COMP knob → Adjust Gate Threshold Hold ALT + Hold TAP + Turn SYNTH knob → Adjust Gate Decay Preset Functions Press & Hold AMP encoder → Enter Save mode Press & Hold ON + TAP switches → Enter Preset Mode (scroll through presets) Press & Hold both switches (while in Preset Mode) → Exit Preset Mode Global Settings Hold ALT + Press AMP encoder → Enter Global Settings Press ALT (while in Global Settings) → Toggle between Settings pages 1 and 2 Other Functions Hold TAP switch (1 second) → Enter Tuner mode Hold ALT button (3 seconds) → Check remaining battery life Hold ON + TAP (while powering on) → Factory Reset I don't think I know the difference between Master Volume (Alt-Tap-Dist), Channel Volume, and the thumb wheel on the size.

If the LED ring is showing red I assume that means you are in FX / edit mode. The red LED is meant to tell you which amp model you are using, not which preset you have loaded. I've just noticed that your post is a couple of months old and you've probably solved this issue, but posting anyway in case anyone else has a similar problem.

We can't have Phaser and Delay simultaneously... : ( How, then are we supposed to play "For The Love Of Money"?

The Double Take (in the Modulation FX) is similar but is not as good in my opinion. I prefer to use a small pitch shift on the right side set to only about 8 cents or so and to 100% mix. I also add 25-30ms of delay (available in Simple Pitch FX). Dry left side and pitch shift of right. This is my preferred way to go stereo if my Mimiq is not available.