Jump to content


  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About myalteregohamish

  • Rank
    Just Startin'
  1. I went to record this evening having done this countless times already and low and behold my Mic doesn't receive an signal. All things checked, no dice. Plugged into my mixer and every things good there. So it looks as though my mic pre may have gone south.
  2. OK, I'm actually quite surprised at how good the redwirez are. I've used a few different brands of IR's and I have to say the ability to mix multiple IR's together to get the exact sound you like is actually pretty amazing. I've actually achieved the sound I like in less time than it takes to dial-in all the different components, EQ's, compressors etc. to get it to where you want it inside helix. I think I have less components in my signal chain now. I also like the fact that you can use it as a channel strip plug in and record directly with the highest quality IR's in logic. My recordings sound crystal clear I'm super impressed. Then once you get the combination of IR's that you like you can mix it down to a final IR export it and imported back into the helix to take with you. Absolutely love it. Thanks for the review OP it made me go out and get the whole big box today.
  3. I'd love an answer to this issue to.
  4. Nvidia in mine also. It's on a Samsung 28-Inch Ultra High Definition LED Monitor (U28D590D).
  5. 3840x2160 and 3008x1692 both look good to me.
  6. I'm running the editor on a 4K screen and it looks fine.
  7. I went with this one, pretty light and can fit two pedals and cables on the sides and back. http://www.ebay.com/itm/251723879837?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
  8. I wish I would've known this before last night, I lost all my money to a guy named Savannah.
  9. That's great can you post the patch? I've been looking for something that does exactly what you played.
  10. I have two basic questions: 1. I have an Axe FX Ev-1 expression pedal. I've connected it to exp-3 on the back of the Helix and it works, sort of. When I configure the delay feedback to increase with the pedal, the pedal gets about halfway through the arc and reaches 100% then starts decreasing till I reach end of the expression arc. What I want it to do is just go from 0% to 100% from the bottom of the expression arc to the top. 2. Is it possible to have a pedal foot switch control a toggle back and forth between exp1 and exp2? I don't want to go to the top of the pedal arc before I can switch it to between pedals using the built in pedal. I hope this makes sense. Thank you for the help.
  11. Maybe one of the funniest posts I've seen written in the forum, really well written.
  • Create New...