Search the Community
Showing results for tags 'position'.
Found 3 results
-
Due to limited space in my studio I was wondering if I can rotate the Powercab so that it’s standing on the side (vertically). I am afraid however that the heat sink might be designed to be in horizontal position. Has anyone tried this?
-
Hi all, New HX Effect user here, first post. It seems there have been many threads regarding the quirks with the expression pedal but I haven't seen this one yet. My issue is that the expression pedal position seems to be affected by the state of another block - namely the Ext Amp control. When the Ext. amp button is off (clean channel on amp), the heel position only returns to 3%, not 0. When ON (overdrive) it does return to 0. This is especially problematic with whammy effects... I expect the heel position to be the unaffected note, but it's 3% sharp. I'm using a line6 EX-1 expression pedal connected with a short TS patch cable. I've tried to swap cables, same result. The result is also the same whether the amp is connect through the EXP 2 jack or not so it's not a grounding issue there. I suspect it may be an interference issue between the 2 EXP/Amp jacks? Anyone else experiencing this? I could make a short video to demonstrate. Thanks -
On POD X3L, physical expression pedal positions, when assigned to a TWEAK parameter, will not be stored upon saving the patch. However, the position or value of the effect parameters in Edit Mode (UI) that the TWEAK Pedal is assigned to, will be stored upon save. This means that when you recall a patch with your expression pedal in the heel position, assuming the expression pedal is set to control a tweak parameter (IE: delay mix), the patch will recall the value you saved the tweak at (IE:Delay Mix 80%) and not the PHYSICAL PEDAL POSITION of the expression pedal (IE: Heel position or NO DELAY MIX) This behavior is similar to the way the POD XTL and Vetta works.
