Using fs 2-5 for effects and fs 8-11 for presets

[janlukemam1]

Hi all,

On my pod hd500x I was able to select preset with the lower fs, navigate through banks with fs 1-7 and assigning effects of each bank to upper fs, all of this without the need of switch mode by pressing fs 6.

On my brand new Helix lt it seems I'm not able to do it: I hope I'm missing something... Anyone can help me?

 

Thanks

[themetallikid]

You would need to utilize the Command Center, and then setup whatever 'layout' you want and put Helix in Stomp Mode, using the Menu button.  

 

go to any preset, stomp the menu button to go into stomp mode.  the buttons will likely all be blank, open up command center and you can program all the buttons (except tap tempo and menu) to be whatever you like (preset, snapshots, stomps)

[silverhead]

Check Global Settings -> Footswitches. Use Knob 2 to select Stomp/Preset for the switch display.

[datacommando]

On 6/8/2023 at 10:09 PM, janlukemam1 said:

I hope I'm missing something... Anyone can help me?

Hi,

 

See Helix Owner’s Manual - page 66 - Global Settings > Footswitches 

 

https://line6.com/data/6/0a020a3f041b611d61cac763b/application/pdf/Helix 3.0 Owner's Manual - Rev F - English .pdf

 

Hope this helps/makes sense.

[janlukemam1]

On 6/9/2023 at 12:08 AM, silverhead said:

Check Global Settings -> Footswitches. Use Knob 2 to select Stomp/Preset for the switch display.

 

Thanks  mate!!

[theElevators]

On 6/8/2023 at 5:09 PM, janlukemam1 said:

Hi all,

On my pod hd500x I was able to select preset with the lower fs, navigate through banks with fs 1-7 and assigning effects of each bank to upper fs, all of this without the need of switch mode by pressing fs 6.

On my brand new Helix lt it seems I'm not able to do it: I hope I'm missing something... Anyone can help me?

 

Thanks

Check out snapshots though!  They are a vast improvement over having to use presets/effects.  Otherwise, you are not taking advantage of the latest Line 6 software improvement...