eagletribe Posted September 2, 2013 Share Posted September 2, 2013 Bought my unit used from Guitar Center in March and I'm just now getting around to figuring out how to use my Pod X3 Live. When I switch to tone 2 theres no sound. Should I be using stereo patch cables? My input for tone 2 is set to "same" which would be "guitar" for tone 1. Any help would be much appreciated, I havent been able to hear any kind of dual tone that this processor is capabable of. Quote Link to comment Share on other sites More sharing options...
eagletribe Posted September 2, 2013 Author Share Posted September 2, 2013 Just flashed the memory and reset everything back to factory and still no sound from tone 2. Quote Link to comment Share on other sites More sharing options...
TheRealZap Posted September 2, 2013 Share Posted September 2, 2013 is tone2 locked? (3rd knob under display, shows padlock locked\unlocked) if its locked, unlock it and change presets... then you're free! this setting will stay even if you flash the firmware.. Quote Link to comment Share on other sites More sharing options...
eagletribe Posted September 2, 2013 Author Share Posted September 2, 2013 no both tones are unlocked Quote Link to comment Share on other sites More sharing options...
Triryche Posted September 3, 2013 Share Posted September 3, 2013 How are you monitoring the sound? Quote Link to comment Share on other sites More sharing options...
eagletribe Posted September 3, 2013 Author Share Posted September 3, 2013 left signal going to line 6 spider 3 30 right signal to flextone 3 2X12 combo Quote Link to comment Share on other sites More sharing options...
eagletribe Posted September 4, 2013 Author Share Posted September 4, 2013 gear.bmp Quote Link to comment Share on other sites More sharing options...
Triryche Posted September 4, 2013 Share Posted September 4, 2013 Do you get both tones through headphones connected to the X3? Quote Link to comment Share on other sites More sharing options...
silverhead Posted September 4, 2013 Share Posted September 4, 2013 Check the Outputs pages. Make sure Tone 2 is not muted. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.