These forums are read only, please use our new forums here.

Main :: Spider IV/Spider Online



line 6 iv stereo to mono
by metallicahp on 2012-12-03 20:38:55

q is possible to do this in the picture, to connect the line 6 150HD a marshall cabinet with 8ohm input



Re: line 6 iv stereo to mono
by fflbrgst on 2012-12-04 07:41:34

You have one wire going to one plug, the other going to a second plug - that won't work!  Not sure what you are trying to accomplish.  The 150HD has two speaker ouputs, both need to be connected to 8 ohm speakers/cabinets.



Re: line 6 iv stereo to mono
by metallicahp on 2012-12-04 18:54:21

my problem is that the marshall cabinet has only one entrance to 8ohm



Re: line 6 iv stereo to mono
by fflbrgst on 2012-12-05 05:21:06

From your diagram, it doesn't seem you know electronics/electric stuff too well, so I would not suggest you try to do this yourself - most likely you will cause damage to your amp.

If you are set on using that cabinet - and don't want to get a 2nd matching cabinet - it will need to be modified to having two input jacks, each at 8 ohms.  I would guess that the cabinet has four 8 ohm speakers, each pair wired in parallel (to give a 4 ohm load), then the two pairs wired in series to give an 8 ohm load.  You woudl need to add a 4 ohm Power Resitor (in series) to each pair, then each pair would be connected to an input jack.  Trying to run both left and right amp ouputs into 1 mono input is going to result in phase issues when you listen to it.



Re: line 6 iv stereo to mono
by Jimmikatt on 2012-12-06 00:50:10

i would just buy another cabniet, if i couldn't afford one, i would just run 1 cabniet.

BTW.. i am using an old Marshall 1960a with my Spider IV 75, but my cab is 16 ohm.

wouldn't hurt running the amp at a higher ohm, but will running a lower ohm.




The information above may not be current, and you should direct questions to the current forum or review the manual.