I just purchased a third Stagesource Speaker. I already had 2 L2t's and I added a L3t. I wanted to use the L3t as a floor monitor. So I hooked them up as follows:
Helix ------ L6 link out----- L2t - L6 link out ------- L3t ------ L6 link out-----L2t
No matter what I do whatever speaker is last in the chain (that makes it speaker 3) there is no output to that speaker. I do have all 110 ohm AES/EBU cables per the manual. All cables have been tested in all configurations and they work.
In theory per the manual my configuration should have the L2t's in stereo and the L3t as a Left + Right sum.
Anyone else use the Stagesource speakers this way? What the heck am I doing wrong?
I have plugged the Helix into each speaker via L6 link and they work fine. Tried tall three cables and they all work.
The speakers also work fine as a array if the Helix is not in the chain? When the helix is in the chain the speakers set themselves as 1, 2, and 3 on back. The #3 speaker gets no output. When The Helix is not in the chain the speakers configure as L, b(both) and R just as they should. What is going on.