jbuhajla

10 stomp mode gets you all of them

Tubes...meh

Did you open a support ticket with line 6?

I was hoping the update would have come out earlier today so I could leave work early.

Yes, and glowy

Have you seen this?

If you suspect the transmitter is dead, you can buy those separately.

That's a pretty catchy tune.

You may want to fiddle around with the little micro switch on the transmitter. If it happens to be stuck, it may not charge correctly. Sounds like your receiver base is fine.

That may take care of the issue.

Yeah, somewhere about 100 posts ago someone mentioned it is going right to 2.50. Good thing too. Bigger IS better.

Woah, I missed the two new amps. Can't wait for the Mesa Lonestar drive channel!

I initially did some mid cuts to try to alleviate that effect, but I just started taking advantage of it rather than fixing it. My main patch is Litigator based with bass/mid/treble all on 10. I vary amp drive from 1.5 to 4.0, and back off channel volume from 9.0 to 6.9. Mid sweep I get a very nice mid range bump that is glorious to my ears. So, I quit trying to fix it. I am sure that affect varies from amp to amp model though.

I LOVED the Satriani factory preset on my AX2/212. It would feed back at such quiet volumes. Maybe we can hope for 3.0. Maybe call is SuperLegacy.

Looking forward to the legacy pitch and filter effects! I missed those.

Yes. Any parameter you want to change with the expression just hold down the knob, set which expression you want to assign it to, then set the max and min. I control about 6 different parameters with one of my expressions. Don't forget, the min value can be larger than the max value to give it a reverse sweep. I do this when I increase amp gain, I also decrease channel volume simultaneously.

I believe Yes.

I don't think it is a bug. I believe it has worked this way all the time. I think it works as designed. However, I think a lot of users are finding it to be optimal to manually change input impedance with the fuzz in play.

If I am not mistaken, all audio stops during the preset switching process, no matter if you have the same block in the subsequent preset. For "true" spillover, an external effect downstream of Helix would have to be utilized. But even then, it would have to be at 100% mix with zero % dry going through because there would be a gap in the dry.

YES! I saw a couple of tidbits in that demo that are making me DREEEEWWWWWLLLLLL.

There are some effects in the Reverb demo that are not currently in 2.30. I wonder if HXFX is running 2.50 and those are new effects on that update.

You can also adjust the levels from your Mac coming in to USB 1/2 IN on the Helix. Go to global settings>INs OUTs>USB 1/2 trim.

I use the 5V power supply and USB cable that came with the unit.

Line 6 is aware of the issue. I am not sure if it will be a fix in the next firmware update coming up soon.

All wireless units will require the receiver to have a power connection. I use the G10. The receiver for G10 uses a 5volt micro USB connection, not a standard 9V supply. The transmitter is rechargeable and gives you about 8 hours of play time between charges.